45. Drive each stake into the ground at a 45° angle away from the tripod. Ensure that the
stake is driven into the ground up to the eyelet of the stake and that the eyelet is facing
the tripod. Clip the carabineer of each of the tensioners to the ring of the guy stake.
45°
Place the Winch in the Retainer
18. Unlock the winch spool by pulling the J-hook and resting on top the winch assembly.
J-hook Locked
19. Use the hitch pin to attach the handle to the winch. Place the top of the winch into the
bottom of the winch holder.
•
For 1 ¼ in / 31.8 mm tubes: The winch tube will go inside the holder.
•
For 2 in / 50.8 mm tubes: The winch tube will go outside the holder.
Attach Handle
Figure 4-67 Use the Hitch Pin to Attach the Handle to the Winch
TP-4549901-G
February 2024
Figure 4-65 Drive Each Stake into the Ground at a 45° Angle
Figure 4-66 Unlock Winch Spool
™ M
R
ANGER
AST
Pull J-hook out
'
O
M
PERATOR
S
ANUAL
Mast is on
this Side of
the Stake
J-hook Unlocked
Winch Holder
Winch
4-27