Disassemble The Mast With Ez Raze™ Option - Will Burt EXPEDITION RANGER MAST Operator's Manual

Table of Contents

Advertisement

™ M
R
O
ANGER
AST
PERATOR
5.2 Disassemble the Mast with EZ Raze™ Option
To disassemble the mast with the EZ Raze™ option, proceed as follows:
1. Unlock the winch, lower payload, and remove the devices from the mast.
2. Slightly loosen the guy ropes to relieve any tension or binding that may exist between
the mast tubes.
3. Loosen the lever on the lower clamp. Remove the base pole by lifting slightly on the
base pole. Tighten the clamp lever so that the next pole remains in place. Place the
base pole (with winch) into the winch holder.
Safety Instruction! Do not allow poles to separate above the lower collar. This will
cause the mast to become unstable.
4. Remove the next mast section using the same process. Once the mast section has been
removed, take up the slack from the cable using the winch on the base pole. Leave
enough slack in the cable to allow for the easy removal of the next mast section.
5. Repeat the above process for the remaining mast sections until all of the mast sections
have been removed. Note: Do not remove the last tube until the tip and carriage are
removed. Store the mast sections into the tube bag.
6. Detach the snap hook on the winch cable from the carriage assembly and wind up the
remaining cable. Remove the base pole (with winch) and store it into the appropriate
bag.
7. Detach the guy ropes from the guy stakes and top pulley and wind them on to the rope
stay. Remove the guy stakes and store them and the guy ropes into the guy bag.
8. Remove the top pulley and the carriage assembly. Make sure all of the pins are properly
stored on the side plates and attachments. Place into the short bag.
9. Remove the guy stakes from the tripod and store them into the guy bag.
10. Collapse the tripod and allow the nested legs to telescope into the tripod legs. Fold the
tripod and tighten all clamps on the tripod legs. You may find it easier and quicker to
store the tripod with the base plates attached. Store the tripod in the wheeled bag.
11. Store all bags and components into the wheeled bag.
5-2
'
M
S
ANUAL
TP-4549901-G
February 2024

Advertisement

Table of Contents
loading

Table of Contents