Figure 4-52 Cup Holder; Figure 4-53 Connect The Bolster Plate To The Carriage - Will Burt EXPEDITION RANGER MAST Operator's Manual

™ M
R O
ANGER AST PERATOR
10. If a cup holder is required, on the end of the extension arm, connect the cup holder to
the carriage with one front pin. Ensure that the top of the cup holder is open (bottom is
closed). Determine the angle of the extension arm and pin using one of the directional
holes. Connect the payload to the cup holder. For payload weights and wind sail areas
outside website specified limits, contact The Will-Burt Company.
11. If a bolster plate is required, on the end of the extension arm, connect the bolster plate to
the carriage with one front pin. The bolster plate can be connected vertical or horizontal.
Determine the angle of the extension arm and pin using one of the directional holes.
Connect the payload to the bolster plate. For payload weights and wind sail areas
outside website specified limits, contact The Will-Burt Company.
Bolster Plate
4-22
'
M
S ANUAL

Figure 4-52 Cup Holder

Figure 4-53 Connect the Bolster Plate to the Carriage

Top (Open End)
Horizontal Placement
TP-4549901-G
February 2024