Long-Term Storage; System Disposal; Figure 7-4 Turn The Nut By Hand In The "+" Direction Shown On The Nut To Ensure The Clamp Is Tight - Will Burt EXPEDITION RANGER MAST Operator's Manual

™ M
R O
ANGER AST PERATOR
4. To ensure that the clamp is tight, by hand, turn the nut in the "+" direction shown on the
nut. The clamp is tight when the nut cannot be tightened further by hand. Do not use
tools to tighten. Oscillate the lever to ensure tightness. The correct tightness should
have minimum movement from side to side. Do not rely on the notch of the nut to mark
the fully tight orientation of the clamp.

Figure 7-4 Turn the Nut by Hand in the "+" Direction Shown on the Nut to Ensure the Clamp is Tight

5. Occasionally, unlocking and locking a clamp causes the screw head to better seat in the
clamp. Unlock the clamp then repeat Steps 3 and 4 to lock and check for proper
tightness.

7.6 Long-Term Storage

When putting the system into long-term storage, ensure the:
•
Mast and components are fully disassembled and are placed into the appropriate bags.
•
Mast and components are stored in a clean and dry environment.

7.7 System Disposal

Dispose of the mast in accordance with the national environmental regulations.
7-4
'
M
S ANUAL
+ Direction
Shown Here
Lock
TP-4549901-G
February 2024