Figure 4-15 Lower Top Tube Until There Is One Hand Width From The Bottom Of The Tube And Lock The Lower Clamp; Figure 4-16 Unlock The 4-Way Guy Collar And Place The Guy Collar Onto The Top Tube - Will Burt EXPEDITION RANGER MAST Operator's Manual

™ M
R O
ANGER AST PERATOR
3. Lower the top tube until there is one hand width from the bottom of the tube and lock the
lower clamp.

Figure 4-15 Lower Top Tube Until There is One Hand Width from the Bottom of the Tube and Lock the Lower Clamp

4. If installing accessories onto the mast, different collars and the accessories must be
installed. Proceed as follows:
•
If installing just the mast, continue with Step 5.
•
If installing the accessories along with the mast, go to Step 8.
Install the 4-Way Guy Collar
5. Unlock the 4-way guy collar (2 in / 50.8 mm or 1 ¼ in / 31.8 mm) and place the guy collar
onto the top of the top tube. Connect the payload to the top of the payload stub. For
payload weights and wind sail areas outside website specified limits, contact The Will-
Burt Company.
2 in / 50.8 mm Collar -
Payload Stub
1 ¼ in / 31.8 mm Collar

Figure 4-16 Unlock the 4-Way Guy Collar and Place the Guy Collar onto the Top Tube

6. Rotate the guy collar so that the four guy lines will land on the ground where desired.
4-8
'
M
S ANUAL
One
Hand
Width
Unlock
Lock
Unlock
TP-4549901-G
February 2024