Table of Contents
Advertisement
4.1 INTRODUCTION
This section of the manual describes routine maintenance procedures and covers general service information.
4.2 CLEANING THE INFLEXION
The exterior of the INFLEXION base should be wiped down periodically to remove dirt and road grime using a soft cloth
or sponge and a mild solution of soapy water.
4.3 ADJUSTMENTS
The proximity switches (Figure 4-1) are intended to stop the actuator when the mast is at 90
senses the position of the mast as it rotates on the clevis assembly and signals the base circuit board to stop when
the actuator is in the correct position.
NIGHTSCAN
TP-4976401-C
October 2018
MAINTENANCE AND SERVICE INSTRUCTIONS
Figure 4-1 Proximity Switches
CHAPTER 4
TM
INFLEXION
o
and when it is stowed. It
CHIEF
4-5
Advertisement
Table of Contents
