Figure 4-32 Place A Tube Into The Bottom; Figure 4-33 Push Up; Figure 4-34 Button In Notch; Figure 4-35 Lower To Ground - Will Burt EXPEDITION RANGER MAST Operator's Manual

™ M
R O
ANGER AST PERATOR
Breech Load Tubes
30. Place a tube (but not the base tube) into the bottom with the white button up and in the
notch in the other tube.
31. While holding onto the tube just loaded, unlock the lower clamp, push the tube up until
only a hand's length is visible, then lock the lower clamp. The puck can also be used to
push up the tubes. Repeat Steps 30 and 31 until all tubes are breech loaded.
Install Base Tube
32. Place the base tube (tube with the base plate attached) into the bottom tube with the
white button up and in the notch in the other tube. Raise the base tube until the white
button seats in the notch. While holding onto the base tube, unlock the lower clamp and
slowly allow the mast tubes and base tube to lower and rest level on the ground. Lock
the lower clamp.

Figure 4-33 Push Up

4-16
'
M
S ANUAL
Push Tube Up
Line Up

Figure 4-32 Place a Tube into the Bottom

Figure 4-34 Button in Notch

Button in Notch

Figure 4-35 Lower to Ground

TP-4549901-G
February 2024