Table of Contents
Advertisement
Install the Accessory Guy Collar
14. Unlock the top and bottom clamps of the accessory guy collar and place the guy collar
onto the top of the top tube. If a second guy collar and lines are wanted for additional
support, place both collars onto the top tube. The second guy collar, if used, can be
tightened onto another tube as it is loaded. The payload can be attached above the guy
collar. For payload weights and wind sail areas outside website specified limits, contact
The Will-Burt company.
Accessory
Guy Collar
15. If using the rigid accessory guy collar, rotate the guy collar so that the four guy lines will
land on the ground where you want. For the swivel guy collar, this is not needed since
the guy plate swivels into any position.
16. Lock the top and bottom clamps.
Connect to Guy Collar
17. Remove the four guy line spools from the guy bag. Connect the single-line, hook ends
from the bottom, to the four holes in the 4-way guy collar (1 ¼ in / 31.8 mm or 2 in / 50.8
mm) or the accessory guy collar at 90° angles.
4-way 2 in / 50.8 mm Guy Collar
18. Let enough slack out of each guy line and place the spools on the ground about 10 ft / 3
m from the center of the tripod in the general area where the stakes will be driven.
Ensure that the lines are free of obstructions and snags. If you are raising the mast
during windy conditions, the mast will need to be guyed as you raise the mast.
TP-4549901-G
February 2024
Line up
Figure 4-22 Place Guy Collar onto Top Tube
Accessory Guy Collar
Figure 4-23 Connect Hook Ends to 4-Way Guy Collar
™ M
R
O
ANGER
AST
PERATOR
Place
onto
Top
'
M
S
ANUAL
Single
Line to
Collar
4-11
Advertisement
Table of Contents
