Figure 4-46 Side Bracket; Figure 4-47 Back View; Figure 4-48 Insert Long Pins; Figure 4-49 Pick An Angle For The Extension Arm And Pin Into Place - Will Burt EXPEDITION RANGER MAST Operator's Manual

Install the Carriage Arms
7. Remove the two side brackets from the small bag. There are two long pins and two short
pins on each bracket. Put the brackets on the inside of the carriage and secure with the
two long pins from the back of the bracket so the pin loops will not snag on the cable that
is installed later.

Figure 4-46 Side Bracket

8. Connect the arm to the bracket with the front small pin. Ensure that the coax loops are
facing down. Also ensure that the 8 holes are at the end of the arm. This will prevent you
from pinning the extension when you pin the arm to the carriage. Pick an angle for the
extension arm and pin into one of the directional holes with the rear small pin.
Pinned from Back

Figure 4-49 Pick an Angle for the Extension Arm and Pin into Place

9. If additional length is required, pull out the extension inside the arm and pin it.

Figure 4-50 Arm Not Extended

TP-4549901-G
February 2024
R
ANGER

Figure 4-47 Back View

Pin Front

Figure 4-51 If Required, Extend and Pin

™ M '
O M
AST PERATOR S

Figure 4-48 Insert Long Pins

Pin Rear
ANUAL
4-21