™ M
R
O
ANGER
AST
PERATOR
4.5 Set Up the Tripod
Set up the tripod as follows:
1. There are five clamps on the tripod. Three clamps are on the tripod legs and two clamps
are in the center of the tripod. To unlock a clamp, push the lever towards the open
position away from the locking tab. To lock a clamp, push the lever to the closed position
and towards the locking tab. When locking a clamp, ensure that the lever locks into
place on the tab. The clamps hold the weight of the mast and payload. See Section 7.5
to check that the clamps are sufficiently tight.
Figure 4-5 Unlocking
10. Loosen the Velcro strap from around the tripod legs. With the tripod on the ground,
attach three base plates to the three tripod legs by pushing the hitch pin through the leg
and securing the other end.
Figure 4-7 Insert Hitch Pin
4-4
'
M
S
ANUAL
Locking Tab
Hitch Pin
Locking Tab
Figure 4-6 Locking
Figure 4-8 Secure Hitch Pin
TP-4549901-G
February 2024