Thermal Pulsing - EWM Tetrix 352 AC/DC Synergic Operating Instructions Manual
Power source
Hide thumbs
Also See for Tetrix 352 AC/DC Synergic:
- Operating instructions manual (109 pages) ,
- Operating instructions manual (53 pages)
Table of Contents
Advertisement
5.2.7.2
Thermal pulsing
The operation sequences basically match the standard welding sequences, but there is an additional
switching back and forth between the main current AMP (pulse current) and the secondary current AMP%
(pulse pause current) at the set times. Pulse and pause times and the pulse edges (
tered in seconds on the control.
Selection
The pulse function can also be deactivated if necessary during the up-slope and down-slope
phases (parameter
099-000140-EW501
30.01.2024
Figure 5-29
Figure 5-30
) > see 5.9 chapter.
Design and function
TIG welding task definition
and
) are en-
47
Advertisement
Table of Contents
Need help?
Do you have a question about the Tetrix 352 AC/DC Synergic and is the answer not in the manual?