Intended Use; Applications; Use And Operation Solely With The Following Machines; Software Version - EWM Tetrix 352 AC/DC Synergic Operating Instructions Manual

3

Intended use

Hazards due to improper usage!
The machine has been constructed to the state of the art and any regulations and stand-
ards applicable for use in industry and trade. It may only be used for the welding proce-
dures indicated at the rating plate. Hazards may arise for persons, animals and material
objects if the equipment is not used correctly. No liability is accepted for any damages
arising from improper usage!
• The equipment must only be used in line with its designated purpose and by trained or
expert personnel!
• Do not improperly modify or convert the equipment!
3.1

Applications

Power source for integration into the automated arc welding system.
• Power source with machine control
• Interface for automated welding (robot or industrial bus interface)
• Connection capability for torch cooling unit
It may be possible to expand the range of functions by using accessories (see the documentation in the
relevant chapter).
3.2

Use and operation solely with the following machines

• BUSINT X11*
• RINT X12
• cool82 U44
• cool82 U45
(*) Please note the interface capabilities!
3.3

Software version

The software version of the machine control can be displayed in the machine configuration menu
(menu Srv) > see 5.9 chapter.
3.4

Documents which also apply

3.4.1

Warranty

For more information refer to the "Warranty registration" brochure supplied and our information regarding
warranty, maintenance and testing at www.ewm-group.com!
3.4.2

Declaration of Conformity

This product corresponds in its design and construction to the EU directives listed in the decla-
ration. The product comes with a relevant declaration of conformity in the original.
The manufacturer recommends carrying out the safety inspection according to national and in-
ternational standards and guidelines every 12 months (from commissioning).
3.4.3

Welding in environments with increased electrical hazards

Power sources with this marking can be used for welding in an environment with increased
electrical hazard (e.g. boilers). For this purpose, appropriate national or international regulations
must be followed. The power source must not be placed in the danger zone!
099-000140-EW501
30.01.2024
WARNING
Intended use
Applications
13