Changing The Filter; Cleaning And Maintenance - Beurer IH 24 Kids Instructions For Use Manual

2. Lift the collection container
3. Fill the saline container
4. Place the collection container
container .
19
5. Place the cover
17
Twist the cover
17
until it clicks firmly into place.
6. Connect the compressed air hose
saline container
19
7. Position the cover
your nostrils. Breathe through your nose.
8. Press the On/Off switch
nebuliser. To start the application, place one
finger over the cover hole
Note
During the application, breathe slowly and evenly
through your nose. Tilt your head slightly in the
opposite direction to the nostril being treated so
that the saline solution can flow deep into the
nose.
9. To pause or stop the application, take your
finger off the cover hole
container .
19
10. Once your nose feels clear again, you can
stop the application. The application should be
stopped at the latest once the maximum filling
quantity has been used.
7.10 Clean the components
See "Cleaning and maintenance".

8. CHANGING THE FILTER

In normal operating conditions, the air filter must
be replaced after approx. 500 operating hours or
one year. Please check the air filter regularly (after
10-12 nebulisation procedures).
Replace the used filter if it is very dirty or clogged.
If the filter has become damp, it must also be
exchanged for a new filter.
Important
• Do not attempt to clean the used filter and
reuse it.
• Only use the manufacturer's original filter,
otherwise your nebuliser may become
damaged and sufficiently effective treatment
cannot be guaranteed.
• Do not repair or maintain the air filter while it is
being used by someone.
out.
18
with saline solution.
19
in the saline
18
on the saline container
in a clockwise direction
to the
7
from below.
carefully inside one of
17
on the back of the
2
on the container.
20
on the saline
20
• Never operate the device without a filter.
To replace the filter, proceed as follows:
Important
.
• First switch the device off and disconnect it
19
from the mains.
• Allow the device to cool down.
1. Pull off the filter cap
Note
If the filter remains in the device after the cap has
been removed, take the filter out of the device,
e.g. with tweezers or similar.
2. Re-insert the filter cap
3. Ensure that it is securely in place.
9. CLEANING AND
MAINTENANCE
Atomiser and atomiser set
Warning
Adhere to the following hygiene instructions to
avoid health risks.
• The atomiser
designed for multiple use. Please note that
different areas of application involve different
requirements in terms of cleaning and hygienic
preparation.
Notes
• Do not clean the atomiser or the atomiser set
mechanically using a brush or similar device,
as this could cause irreparable damage and it
will mean that the best treatment results can
no longer be guaranteed.
• Please consult your doctor about the
additional requirements in terms of the
hygienic preparation required (hand care,
handling of medication/inhalation solutions)
for high-risk groups (e.g. patients with cystic
fibrosis).
• Ensure thorough drying after each cleaning
or disinfection process. Residual moisture or
wetness can represent an increased risk of
bacterial growth.
Preparation
• Immediately after each treatment, all parts of
the atomiser
22
towards the front.
5
with a new filter.
5
and atomiser set are
8
and the atomiser set used
8
C