Steps
1. Go to System → System Settings → Network → Network → Other .
2. Set Multicast parameters.
Note
When adding device through network video security client, multicast group IP address should
●
be the same as the device multicast IP address.
For IPv4, it covers Class-D IP ranging from 224.0.0.0 to 239.255.255.255 and it is
●
recommended to use an IP address ranging from 239.252.0.0 to 239.255.255.255. When
adding a device to the CMS software, the multicast address must be the same as that of the
device.
3. Optional: Turn on Enable Network Camera Occupation Detection.
4. Click Save.
4.2 Platform Access Settings
4.2.1 Configure Hik-Connect
Hik-Connect provides mobile phone application and platform service to access and manage your
video recorder, which enables you to get a convenient remote access to the video security system.
Steps
1. Go to System → System Settings → Network → Platform Access → Hik-Connect .
2. Turn on Enable, and the service terms will pop up.
3. Accept the service terms.
4. Click
to set verification code.
Network Video Recorder User Manual
Figure 4-4 Other Settings
Figure 4-5 Hik-Connect
9