Linkage Configuration - HIKVISION DS-7600NI-I2 Series User Manual

Linkage Method
Alarm Output
Record
8. Click Save.

13.2 Linkage Configuration

Configure parameters for event linkages.
Steps
1. Go to Event Center →
2. Click Email to configure email parameters.
Item
Server Authentication
SMTP Server
SMTP Port
Enable SSL/TLS
Sender
Sender's Address
Select Receivers
Attached Image
Enable 3 Attached Images
for Perimeter Protection
Interval
Network Video Recorder User Manual
The alarm output can be triggered by the alarm input, motion
detection, video tampering detection, face detection, line crossing
detection, and any all other events.
When an alarm is detected, the selected channel would record
videos.
Note
Video recording schedule shall be enabled for the channel,
otherwise this linkage would be invalid. You can go to System →
Storage Management → Storage Schedule → Video Recording to
configure video recording schedule.
→ Linkage Configuration .
Table 13-13 Email Linkage
Enable it if the SMTP server requires user authentication and
enter the user name and password accordingly.
The IP address of SMTP Server or host name (e.g., smtp.
263xmail.com).
The SMTP port. The default TCP/IP port used for SMTP is 25.
Enable SSL/TLS if the SMTP server has the requirement.
The sender name.
The sender's address.
Select the receiver. Up to 3 receivers can be configured.
Send email with attached alarm images.
When a perimeter protection event is triggered, the device
would send an email with 3 attached alarm images.
The time interval for capturing the attached images.
Description
Description
60