Perimeter Protection - HIKVISION DS-7600NI-I2 Series User Manual

Linkage Method
Notify Surveillance
Center
Alarm Pop-Up Window
Buzzer
Send Email
Alarm Output
Record
8. Click Save.

13.1.2 Perimeter Protection

Before You Start
If human or vehicle target requires to be detected, ensure your camera supports this function or
the engine is running Perimeter Protection algorithm.
Steps
1. Go to Event Center →
2. Select a camera.
3. Optional: Turn on Enable AI by NVR.
The device will analyze the video, and cameras only transmit video stream.
4. Select an event type.
5. Turn on Enable.
6. Click Rule Settings to set the rule.
Network Video Recorder User Manual
Table 13-2 Linkage Method Description
The device can send an exception or alarm signal to the remote
alarm host when an event occurs. The alarm host refers to the PC
installed with client software (e.g., iVMS-4200, iVMS-5200).
When an alarm is triggered, the local monitor displays the alarm
pop-up window.
When an alarm is detected, the buzzer will make an audible beep.
The system can send an email with alarm information to a user or
users when an alarm is detected.
The alarm output can be triggered by the alarm input, motion
detection, video tampering detection, face detection, line crossing
detection, and any all other events.
When an alarm is detected, the selected channel would record
videos.
Note
Video recording schedule shall be enabled for the channel,
otherwise this linkage would be invalid. You can go to System →
Storage Management → Storage Schedule → Video Recording to
configure video recording schedule.
→ Event Configuration → Perimeter Protection .
Description
48