Opening The External Cover; Periodic Maintenance; Spare Parts; Disposal - Telair DualClima 8400H Installation Manual And User's Manual

6.4 Opening the external cover

EN
1
4
7
The external cover, made of ABS plastic, is at-
tached to the base with 6 re-usable rivets.
• To extract the rivets, follow the steps shown in
("Fig. 19").
• Use a flat-headed tool to push the core of the
rivet inwards by about 5 mm (ref. 1, 2 and 3).
Remove the rivet from its hole (rev. 4 and 5).
• Before re-using it, push the core of the rivet
outwards by about 5 mm (rev. 6).
• Re-insert the rivet fully into its hole (rev. 7 and
8)
• Press the core of the rivet flush with the outer
body (rev. 9).
- 20 - DualClima 8400H - DualClima 8400HB - DualClima 8400HN - DualClima 12500H
2
5
8
Fig. 19
Translation of the original instructions

6.5 Periodic maintenance

• Remove the external cover and remove any
leaves or other deposited material.
• Clean the heat exchangers (evaporator and
condenser) using a suitable detergent and
rinse with water.
3
• Check that the condensate drain holes are un-
obstructed.
• Check that the seal gaskets are in good con-
dition and there is no water infiltration into the
vehicle.
• Remove any traces of oxidation from metallic
6
parts and protect the area with suitable paint.
• Check that the insulation on the electrical wires
is in good condition and remove any traces of
oxidation or moisture.
• Check that all screws are properly tightened.
9

6.6 Spare parts

If the event of repair or replacement of parts, use
only original spare parts.
7.

DISPOSAL

The materials used for the construction of this ap-
pliance are recyclable. In the event of disposal, it
is advisable to take the unit to a specialist work-
shop or designated waste collection centre.
All waste materials must be disposed of
properly by taking them to authorised
waste collection centres
Rev.011