Table of Contents
Advertisement
In order to install the air conditioner, you must first
make sure the roof of the vehicle is able to hold its
weight. If not, reinforce it. Choose a central, level
and flat area on the roof. Make sure that no obstacle
inside the vehicle can hinder fastening of the diffuser
[Fig.1 ref. 4] and the exit of the cooled air from the
adjustable outlets [Fig. 1 ref. 5].
To install the air conditioners, you can choose ei-
ther of two solutions:
Remuve existing rooflight and use aperture
Cut new aperture.
4.2.1 Using rooflight aperture
You can do so on condition that the aperture of the
rooflight measure of 400 x 400 mm. For the
dimensions of the air conditioners and of the holes
required to install them, refer to figure 2.
400
400
395
395
400
400
620
615
615
1010
1010
GB
Remove existing rooflight and sealants making sure
roof surface is clean and even [Fig. 3 ref. 1] Seal
any screw holes and or cable entrance holes so
that no water can penetrate the roof space, using a
suitable sealent [Fig. 3 ref. 2].
silicone, lining - must not be disposed of in the
open, but in special containers and delivered
to a Waste Collection and Disposal Centre.
4.2.2 Opening a new hole
Choose a flat level position on the vehicle roof
beteween the support structure. Mark the aperture
400 x 400 mm square [Fig. 4 ref. 1].
Carefully cut out the opening on the roof, making
sure that no damage will be caused e.g. cables,
hoses, furniture, fittings. [Fig. 4 ref. 2].
gloves before using any power tools or hand-
saws.
Make a reinforcing frame along the perimeter of
the opening. Make a hole on one side in order to
lead the power supply cable through [Fig. 5].
2
All the waste material - glue,
1
2
Wear safety goggles and
3
- 7 -
Hide quick links:
Advertisement
Table of Contents
