Telair Silent 8400H Manual For Installation And User Manual

Telair Silent 8400H Manual For Installation And User Manual

Monoblock air conditioner

Advertisement

MANUAL FOR INSTALLATION AND
USER MANUAL
v.002 July 2015

Advertisement

Table of Contents
loading

Summary of Contents for Telair Silent 8400H

  • Page 1 MANUAL FOR INSTALLATION AND USER MANUAL v.002 July 2015...
  • Page 2 Via E. Majorana , 49 48022 Lugo (RA) ITALY “CE” DECLARATION OF CONFORMITY in compliance with EC Machine Directive 2006/42/EC It is hereby declared that the air conditioner specified below has been designed and built in compliance with essential safety and health requisites as per the European Directive on Machine Safety. This declaration is rendered null and void in the event of incorrect assembly, improper use or modifications made to the machine without our written approval.
  • Page 3: Table Of Contents

    CONTENTS 1 INTRODUCTION ........................4 Purpose and field of application of this manual ..............4 Key to symbols and definitions ..................4 General information ......................4 2 IDENTIFYING THE AIR CONDITIONER ................... 5 Components (fig. 1) ......................5 ID label ..........................5 Technical specifications ....................
  • Page 4: Introduction

    1 INTRODUCTION Key to symbols and definitions Indicates risk of serious injury or death and that the utmost care must Always consult this manual carefully be taken. before carrying out any work on the conditioner. Situation that might arise Purpose and field of application of during the working life of a product, system or this manual plant which could cause harm, injury,...
  • Page 5: Identifying The Air Conditioner

    2 IDENTIFYING THE AIR ID label CONDITIONER Model Components (fig. 1) Serial number Type of electrical power Ventilation grille Cooling capacity Upper cover Heating capacity Machine body Type and quantity of coolant gas Technical specifications label GWP refrigerant gas Connector duct Air flow rate Air/conditioner block tunnel Absorbed power, cooling...
  • Page 6: Technical Specifications

    Technical specifications Weight Weight SILENT 8400 H, packaging excluded: SILENT 8400 H 34 kg Power supply 230 V 50 Hz Consumption 4.2 Ampere Peak current 18 A (0.15 sec.) Handling Absorbed power, cooling 900 Watt Absorbed power, heating 920 Watt Packaged air conditioners can be moved Cooling capacity 8400 Btu/h...
  • Page 7: Installation

    Installation Before installing the unit all the following electrical connections on the vehicle must be disconnected. • Positive battery lead. • Generator (where applicable). • Outdoor power socket. Failure to observe the above can lead to power discharges. Before climbing on top of the vehicle check that the roof is designed to be walked on.
  • Page 8: Power Lead

    Use protective gloves and goggles before using electrical tools or handsaws. Cut the new opening in the roof carefully with a saw: be careful not to cut any electrical wires (fig. 4 ref. 2). 4.2.3 Power lead To power the air conditioner it is necessary to lay a 3-pole lead (phase-neutral-earth): each wire must have a minimum cross-section of 2.5 mm...
  • Page 9: Positioning The Air Conditioner

    aligned with the square 395 x 395 mm Before making opening of the hole on the roof. electrical connections always make sure Line the four external sides of the connecting the power is disconnected inside the duct with adhesive insulating tape so that it distribution board and that the wire ends adheres to the folded fixing edge (fig.
  • Page 10: Connecting The Power Lead

    contact with the horizontal surface of the tunnel. The resulting connection is shown in Fig.13. Incorrect tightening can Connecting the power lead damage the support base of the air conditioner, compromise the seal and Connect the 230 Vac power lead to the one cause loud noise inside the vehicle when on the just-installed conditioner (fig.
  • Page 11: Installing The Diffuser

    The SILENT 8400H provides cold air during the summer months and hot air in winter. If the vehicle has been left in the sun for some time it is good practice to open...
  • Page 12: Preliminary Checks

    • Preliminary checks Clean the air conditioner with detergent solutions only; never use petrol or Before switching on the air conditioner for the solvents. • very first time: If the vehicle is garaged for the winter • Check that condensate drainage holes disconnect the air conditioner from the are unobstructed.
  • Page 13: Remote Control Key Definitions/ Functions

    • 1 - Secondary keys access flap When the control reception sound signal 2 - Display (see Fig. 19) is no longer audible in the indoor unit, or 3 - On/Off control to start/stop the air when the transmission symbol on the conditioner.
  • Page 14: Setting System Time On Remote Control

    5.10 Cold operation mode 1) Press the On/Off key 2) Press the MODE key repeatedly until the display shows the COLD mode symbol. 3) Set your required temperature with the keys +TEMP and -TEMP. 4) Press the FAN key several times until you reach your required ventilation setting.
  • Page 15: Diffuser Display

    5.12 Diffuser Display 5.14 Timer setting • Press the TIMER key on the remote The diffuser has a display which also control: the start time ON indicator is incorporates the remote control IR receiver. activated • By using the +HOUR and –HOUR keys, set the start time •...
  • Page 16: Safety Regulations

    6 SAFETY REGULATIONS In the event of air conditioner malfunctioning, before carrying • out any conditioner servicing check:: Always use properly earthed power • sockets with differential safety switches. the power supply is never less than 205 • Never use the air conditioner near •...
  • Page 17: Disposal

    • 8 DISPOSAL All traces of oxidation must be removed and metallic parts coated with a suitable paint. Always contact specialised workshops when • Check that wiring insulation is in good it is necessary to dismantle and dispose of condition and eliminate any traces of the air conditioner.
  • Page 18: General Terms Of Warranty

    GENERAL TERMS OF WARRANTY TELAIR guarantees its products against any construction material and/or manufacturing faults and defects. The right to warranty cover for new products is valid for a period of 24 months from the time of handing over to the end user, or for a maximum of 1000 operating hours, whichever limit is reached first.
  • Page 19: Wiring Diagram

    WIRING DIAGRAM...
  • Page 20: Spare Parts List

    SPARE PARTS LIST...
  • Page 22 Pos/Code/Q.tà Descrizione/Description Dèsignation/Bezeichnung Beschrijving/Descripcion Coperchio superiore Couvercle supérieur Bovenste afdekking 1 / 06192 / n.1 Top lid Obere Abdeckung Tapa superior Coperchio dell’evaporatore Couvercle de l’évaporateur Deksel van de verdamper 2 / 05931 / n.1 Evaporator cover Deckel des Verdampfers Tapa del evaporador Gruppo Evaporatore Unité...
  • Page 23 Filtro aria Filtre de l'air Luchtfilter 81 / 03510 / n.2 Air filter Luftfilter Filtro de l'aire Targa trasparente Telair Plat trasparent Telair Trasparente plaat Telair 82 / 03492 / n.1 Transparent plate Telair Durchsichtige Platte Telair Placa trasparent Telair Targa trasparente ricevitore Plat trasparent pour le récepteur...

Table of Contents