Table of Contents
Advertisement
HOW TO SET COIN COMPARITOR MECHS
Coin comparators come standard on a Skee Ball game that is not specifically ordered for use with a
card swipe system. These mechs are specifically designed to work with any size coin or token.
Coin mechs can be swapped between games to identify a faulty mech.
3 items to check on the coin mech:
Game not coining up.
3.) This is the pulse
speed position. Set to the
middle position for 50 ms
Ensure game makes sound
when coin switch is triggered.
Verify communication
between Motherboard and
I/O Aux Board.
Game set to large amount of
credits per game.
Faulty coin mech
2.) Ensure this switch is up -
to the N.C. position. (For
normally closed operation)
Check coin switch—Should be wired normally
closed. (NC) Switch should be up.
Check wiring to I/O Aux Board.
Part #'s AACE18004 & AACE18005
Refer to "Game does not coin up" troubleshooting
section.
Check options in menu.
Swap mech between games to identify a faulty
mech
10
1.) Slide back the
housing and replace
the yellow plastic
chip with the coin or
token you are using.
The mech will
compare the coin
inserted to this coin.
Advertisement
Table of Contents
