Starting/Stopping The Plc Of The Cnc - Mitsubishi Electric MELDAS C6 Programming Manual

Hide thumbs Also See for MELDAS C6:

Table of Contents

1. PLC Development Environment Using GX Developer

1.3.4 Starting/Stopping the PLC of the CNC

Before writing a ladder program, you must stop the PLC of the CNC.

(1) Operation procedure

Perform the following operation from GX Developer to start the operation screen.

[Online] → [Remote operation] or Alt + 6

On the following screen, set "STOP" or "RUN" in the [PLC] part under [Operation] and click

[Execute]. The current status is displayed in [PLC status] under [Connection target information].

(Note) The operation other than "RUN" or "STOP" can not be performed.

The operation is completed when the following dialog appears. Click [OK]. The status after

completion appears in [PLC status] on the remote operation screen displayed behind. If the status

does not change, check whether an alarm is displayed or not on the CNC side.

1.3 Developing PLC Programs

Get other manuals https://www.bkmanuals.com