Writing The Plc Program To The Cnc - Mitsubishi Electric MELDAS C6 Programming Manual

1. PLC Development Environment Using GX Developer

1.3.5 Writing the PLC Program to the CNC

The following indicates how to write ladders from GX Developer to the CNC (especially the
restrictions and C64 series-specific operations).
(1) Operation procedure
Perform the following operation from GX Developer to start the operation screen.
[Online] → [Write to PLC]
On the following screen, choose the ladder file to be written from the [File selection] tab and click
[Execute].
You can command RUN/STOP of the PLC using [Remote operation] under [Related functions].
(Note) As [Target memory], only [PLC RAM/Device memory] is valid.
Do not set the other tabs ([Device data], [Program], [Common], [Local]) than [File
selection].
1.3 Developing PLC Programs
- 17 -
Get other manuals https://www.bkmanuals.com