Advanced Power Board Replacement Kit 24U939
Tools Required
•
6 mm hex wrenches
•
1/4 inch nut driver
•
5 mm hex wrench
•
Phillips screwdriver (#2)
•
Torque wrench 15 ft-lb (20 N•m)
Disconnect the Power Wires
1. Follow the instructions in Prepare for Repair,
page 16.
2. Using a 6 mm hex wrench, remove the four bolts
that hold the wiring box cover. Place the bolts in a
safe location.
3. Disconnect the wires from the post and ground the
screw inside the cover.
4. Remove the power cable and conduit from the
electronics cover.
3A4801G
Advanced Power Board Replacement Kit 24U939
F
. 49: Wiring Box Cover
IG
Remove the Electronics Cover
NOTICE
To avoid equipment damage, carefully support the
cover when removing the last bolt. Hold the cover
horizontally and take care that the wires are not
pulled tight.
1. Using a 6 mm hex wrench, remove the 12 bolts that
hold the electronics cover.
2. Support the cover after the bolts are removed to
prevent excess strain on the wires inside the E-Flo
DC.
F
. 50: Electronics Cover
IG
47