Installation
Change the Oil
NOTE: Change the oil after a break-in period of
200,000–300,000 cycles. After the break-in period,
change the oil once a year. Order two of Part No.
16W645 ISO 220 silicone-free synthetic gear oil.
Drain the Oil
1. Place a minimum two–quart (1.9 liter) container
under the oil drain port. Remove the oil drain plug
(25). Allow all oil to drain from the motor.
2. Reinstall the oil drain plug (25). Torque to 25 ft-lb (34
N•m).
F
. 3: Oil Drain Plug
IG
18
Fill the Oil
1. Open the fill cap (P) and add Graco Part No.
16W645 ISO 220 silicone-free synthetic gear oil.
Check the oil level in the sight glass (K). Fill until the
oil level is near the halfway point of the sight glass.
The oil capacity is approximately 1.5 quarts (1.4
liters).
2. Reinstall the fill cap.
F
. 4: Sight Glass Location
IG
3A4801G