Remove The Fan Bearing Seal; Install The Fan Bearing Seal; Install The Gear Cover; Install The Fan - Graco E-Flo EM0011 Repair Parts

Remove the Fan Bearing Seal

1. Remove the fan coupler (62) from the gear cover (2).
F . 15: Fan Components
IG
2 Gear cover
26 Fan bearing seal
48 Snap ring
49 Fan bearing assembly
62 Fan coupler
2. Using the snap ring pliers, remove the snap ring
(48).
3. Pull out the fan bearing assembly (49).
4. Tap the edge of fan bearing seal (26) with a flat
head screwdriver and hammer until it folds and can
be pried out.

Install the Fan Bearing Seal

1. Insert the fan bearing seal (26) into the gear cover.
2. Grease the shaft of the fan bearing assembly
and insert it into the fan bearing seal (26).
3. Reinstall the snap ring (48).
4. Insert the fan coupler (62) into the fan bearing
assembly.
3A4801G
5. Press the new shaft seal (26) into the gear cover.

Install the Gear Cover

1. Place the gear cover on the motor housing and
secure it with the eight 6 mm hex screws (24) and
washers (43). Torque to 15 ft-lb (20 N•m).
2. Using a 3 mm hex wrench, secure the fan cover (55)
with the three screws (56).
F . 16: Fan Cover
IG
55 Fan cover
56 Screws
3. Fill with oil. See Fill the Oil, page 18.

Install the Fan

1. Press the fan (53) onto the fan shaft (49).
(49)
2. Attach the retaining clip (54) into the groove in the
fan shaft, lining up the clearance flat of the shaft
with the clip ends.
3. Using a 3 mm hex wrench, secure the fan cover
with the three screws (56).
Fan Only Replacement Kit 26A396
(55)
25