Install The Gear Cover; Install The Fan; Replace The Output Shaft Bearing - Graco E-Flo EM0011 Repair Parts

Gear and Output Shaft Replacement Kits: 26A401 (series A/B), 26A398 (series C), and 26A399

Install the Gear Cover

1. Remove and replace the gear cover gasket (23).
Place grease on the gasket groove of the gear
cover in three or four places before you press the
gasket into place.
2. Place the gear cover (2) on the motor housing and
secure with the eight 6 mm hex screws (24) and
washers (43). Torque to 15 ft-lb (20 N•m).
F . 23: Gear Cover
IG
2 Gear cover
24 Hex screws
43 Washer
30
3. Torque the 2nd stage adjuster (15) clockwise to 150
in-lbs (17 N•m). Back off several turns
counterclockwise, and then torque the 2nd stage
adjuster clockwise to 100 in-lbs (11 N•m).
4. Torque the 1st stage adjuster (44) clockwise to 100
in-lbs (11 N•m). Back off several turns
counterclockwise, and then torque the 1st stage
adjuster clockwise to 70 in-lbs (8 N•m).
5. Screw the jam nuts into the outside of the gear
cover. Torque to 40 ft-lbs (54 N•m).

Install the Fan

1. Press the fan (53) onto the fan shaft (49).
2. Attach the retaining clip (54) into the groove in the
fan shaft, lining up the clearance flat of the shaft
with the clip ends.
3. Using a 3 mm hex wrench, secure the fan cover (55)
with the three screws (56).
Replace the Output Shaft
Bearing
1. Unscrew and remove the output shaft bearing (19)
from the motor. See Parts — Gear Box, page 10.
2. Install the new bearing (19), bumper (31), and
washer (12). Torque to 70 ft-lb (95 N•m).
3. Fill with oil. See Fill the Oil, page 18.
4. Reconnect the lower to the motor.
3A4801G