Execution - Reflex Fillcontrol Auto Operating Instructions Manual

6.3

Execution

ATTENTION
Damage due to improper installation
Additional device stresses may arise due to the connection of pipes or system equipment.
• Ensure that pipes are connected from the device to the system without stresses being induced.
• If necessary, provide support structures for the pipes or equipment.
Note!
Starting up of the pump causes vibration in the device. This transfers loud noises into the system pipes.
– Connect the pipes to the device using flexible connections.
In systems with a diaphragm expansion tank, the device must be installed in the vicinity of the tank. To ensure that the required filling
pressure for water make-up is recorded by the pressure transducer in the device. The filling pressure depends on the minimum operating
pressure of the facility system. For calculating the minimum operating pressure,see chapter 7.2 "Determining the P
pressure for the controller" on page 26 .
Proceed as follows for the installation:
1. Position the device.
2. Create the water-side connections of the device to the system.
– Use connections with the same dimensions at the device for all lines.
3. If required, create the interfaces according to the terminal plan.
Fillcontrol Auto — 06.07.2016 - Rev. B
Installation
minimum operating
0
English — 17