Adjusting The Idle Speed - Ducati 1098 2007 Manual

section
D 5

Adjusting the idle speed

A
Notes
This adjustment should be carried out in an ambient temperature equal to or greater than 19 °C.
Connect the inserts of the Exhaust Gas analyser part no. 88713.1010 to the outlets on the exhaust pipes, using the connection
fittings (19).
B
C
D
Make sure the throttle butterfly valves are seated against the stop screws (throttle twistgrip released).
Make sure that the throttle cable freeplay is correctly adjusted.
Reset the TPS to zero as described in the paragraph "Resetting the throttle position sensor (TPS)" in this section.
E
Check:
- that the throttle angle value read by the DDS tester with the engine switched off is 2.7° ± 0.1°; if not, repeat the procedure
"Resetting the throttle position sensor".
Open the bypass screws (20) from the fully closed position by a 3/4 turn.
F
G
H
L
M
Start the engine and wait for the coolant temperature to reach 75 °C.
N
When the coolant temperature exceeds 75 °C, start the adjustment procedure described here below, bearing in mind that on
completion of the operation the coolant temperature should not be greater than 100 °C.
Test the CO level, checking the value is greater than 0.7 on both cylinders.
Warning
If the engine is shut off, before proceeding with adjustment of the CO level, wait a minute after restarting for the enrichment
P
phase to finish (Kranc time).
62
Use and maintenance
20
WWW.PlanDeGraissage.ORG
19
88713.1010
20
1098/1098S - M.Y. 2007 - edition 00