Ducati 1098 2007 Manual page 282

section
H 2
Fit the oil seal (2) (with the rim facing upwards) and inner race (A) of bottom bearing (3) onto the steering stem after heating it for
about 10 minutes to 120 °C.
A
Fit drift part no. 88713.1072 into steering stem. Keep the inner race (A) pressed against the oil seal (2) manually for at least 10 -
15 seconds.
Lubricate inner bearing race (A) with the recommended grease.
Fit the ball race (B) to the steering stem (D) with the smaller diameter of the cage facing upwards and grease the ball race.
Insert the steering stem in steering head and push it until it becomes axially seated.
B
C
D
E
F
Fit the bottom yoke assembly to frame.
G
Grease the ball race (B) and fit it to frame top outer race (C).
Fit the inner race (A) of the upper bearing (3) to the steering head, with the larger diameter side of the race facing upwards.
Install the oil seal (2) with the flat side facing upwards.
H
L
M
N
P
12
Frame
A
2
88713.1072
A
2
A
B
WWW.PlanDeGraissage.ORG
D
B
A
2
2
3
1098/1098S - M.Y. 2007 - edition 00