Overhauling The Rear Shock Absorber - Ducati 1098 2007 Manual

section
G 7

Overhauling the rear shock absorber

Before dismantling the shock absorber, measure the spring preload length (L). The same length must be restored on re-assembly.
Removal of the rear shock absorber
Slacken off locknut (A) and spring adjuster nut (B) with a pin wrench or special tool.
Remove the retaining ring (C) and the spring.
Inspect the shock absorber for signs of oil leaks and other problems.
Renew the shock absorber if necessary.
Refitting the rear shock absorber
Fit the spring into its seat in the shock absorber with the tapered end towards the lower mounting.
Fit the spring retaining ring (C).
Screw in the spring adjuster nut (B) to obtain the previously measured length (L).
Notes
One full turn of the adjuster nut changes the length of the spring by 1.5 mm.
Tighten down the lock nut (A) against the adjuster (B).
WWW.PlanDeGraissage.ORG
1098/1098S - M.Y. 2007 - edition 00
Wheels - Suspensions - Brakes
L
B
A
B
A
C
C
A
B
C
D
E
F
G
H
L
M
N
P
55