Ducati 1098 2007 Manual page 678

section
P 5
Changing the rear turn signal bulbs
Undo the screws (2) and remove the cover (3).
A
Disconnect the wiring (A) of the turns signals (4) and (5). Unscrew the nuts (6) and remove the turn signals.
When refitting, position the turn signals by inserting the wires (A) through the relative apertures in the number plate holder (7).
Slide the nuts (6) along the wires (A) and screw them onto the turn signals to secure them to the number plate holder.
Tighten the nuts (6) to the specified torque (Sect. C 3).
Refit the cover (3) and tighten the screws (2) to the specified torque (Sect. C 3).
B
C
D
E
F
G
Renewl of the rear parking light and brake light
Remove the seat cowling as indicated in Sect. E 3.
Unscrew the bolts (8) and remove the parking light and brake light unit (11). Remove the spacers (9) and grommets (10) from the
old unit and fit them to the new unit (11). Fit the new parking light and brake light unit (11) to the seat cowling, tightening the
bolts (8) to the specified torque (Sect. C 3).
H
L
M
Refit the seat cowling as indicated in Sect. E 3.
N
P
76
Electric system
A
8
1
WWW.PlanDeGraissage.ORG
2
3
7
5
A
6
4
9
10
1098/1098S - M.Y. 2007 - edition 00