Control Panel - Korg Sound on Sound Owner's Manual

Control Panel

1. LCD display
Indicates various settings. When a rectangular frame is displayed in
the lower area, you can input or change parameter values by touching
and sliding over this area with your finger (see page 12).
2. Controller buttons
The , , , + and ‐ buttons are used to control recording and play‐
back and adjust various settings in Menu mode.
3. MENU button
Press this button to enter Menu mode to access various settings (see
page 25). Pressing the Stop button while holding down the MENU but‐
ton will cause the unit to enter Hold mode, in which all button opera‐
tions will be disabled. To cancel Hold mode, press the Stop button
again while holding down the MENU button.
4. FX button and indicator
Press this button briefly to turn the effects on (the LED will light up) or
off (the LED will turn off). Press and hold down the button to access
the effect setting page (see page 22).
5. A/B LOOP button and indicator, A/B SET button
These buttons enable you to set up loop playback and recording (see
page 19).
6. Stop button
Press this button to stop recording or playback, or cancel the setting.
7. Record (SOUND ON SOUND) button and indicator
Press the Record button to place the unit in Record Ready mode. The
Record indicator will flash. Press the Record button again to start
recording while the unit is in Record Ready mode. The Record indica‐
tor will light up steadily.
8. Clip indicators L & R
These indicators will flash red during clipping.
9. Internal stereo microphone
10. Speaker
The built‐in speaker will be muted if the headphone jack is connected.
The speaker will also be muted to avoid feedback while you are
recording via the built‐in or external microphone, setting the input
level, using the tuner, or when the unit is in Record Ready mode.
11. Power button (see page 8)
12. UNDO button and indicator (see page 21)
10