Table of Contents
Advertisement
>> Ensure that the welding equipment settings are suitable for the verification process in question.
3.
On the ArcValidator RC screen, select the equipment type (wire feeder), verification process (manual or automatic)
and the verification grade (standard or precision).
4.
Define the equipment make and model.
5.
Start the verification process and follow the on-screen instructions.
In manual verification mode, the user is required to adjust the verified values manually on the welding equipment,
operate the welding torch and then fill in the values shown on the welding equipment's display during the simulated
welding run.
6.
When the verification is ready, turn the equipment off.
7.
Transfer the verification data to the computer using the DataStick (as described in "Transferring verification data to
computer" on the next page).
8.
Using the ArcValidator computer software, open and finalize the reports and export the certificates (as described in
"Viewing and editing verification reports" on page 25).
For adding and editing equipment models and updating ArcValidator RC software, refer to "Managing equipment types
and models" on page 28.
© Kemppi
23
ArcValidator
Operating manual - EN
AVPCRC / 2224
Advertisement
Table of Contents
