Installation On Non-Original Substructures Of The Unit Manufacturer - Rational iCombi Pro Original Installation Instructions

2. Adjust the height adjustment on the castors with a wrench until the castors
are securely in position.
3. Tighten the grub screw on the castors using an Allen key.
Secure the mobile stand
Damage to the power and gas supply due to moving
Also secure the unit with a suitable retaining unit against slipping on the rear
wall (retaining unit is not included in the scope of delivery).

5.2.4 Installation on non-original substructures of the unit manufacturer

Risk of crushing due to the weight of the unit
Hands, fingers and feet may be crushed.
Wear suitable protective clothing during transport.
n
Risk of injury due to inadequate substructure
Setting up the unit on inadequate support substructures can result in injury
and damage to the unit and substructure.
The substructure must meet the static requirements for the weight and
n
dimensions of the unit. Check whether the static requirements are met.
The tabletop must be at least 2mm [1/8 inch] thick metal.
n
Units in unit sizes XS to 10 full size can be installed directly on non-original sub-
structures of the appliance manufacturer.
Only install the unit on substructures that are statically suitable for this purpose.
Note the unit weight (Unit weight [} 17]) including the maximum load.
If the unit is built on a non-original substructure, the manufacturer's liability shall
be voided.
80.06.083_iCombiPro-iCombiClassic_IM_en-US
NOTE
CAUTION
CAUTION
5 | Setup
39 / 100