ZOLL AED Pro Service Manual page 13

This chapter describes the procedures for routine testing of the AED Pro
A test typically consists of multiple steps, each of which requires a pass/fail rating. For each
step, perform the specified action and then verify that the expected results occur. If all expected
results occur, assign a "Pass" rating to the step; otherwise, assign it a "Fail" rating.
This chapter includes the following inspection and test procedures:
•
"1.0
•
"2.0
• "3.0
• "4.0
• "5.0
• "6.0
• "7.0
• "8.0
• "9.0
• "10.0
• "11.0
• "12.0
• "13.0
• "14.0
• "15.0
9650-0309-01 Rev. E
Maintenance Tests
Physical Inspection" on page 1-3
Power Supply Test/Current" on page 1-4
Power ON Test" on page 1-5
Pediatric Mode/Electrode Connector Type Test" on page 1-6
Defibrillator Energy Test" on page 1-7
Battery Type Test" on page 1-9
Establish Communication" on page 1-10
Internal Discharge Test" on page 1-11
Patient Impedance Calibration" on page 1-13
ECG Lead-Off Detection" on page 1-15
ECG Offset Calibration" on page 1-16
Real Time Clock Test" on page 1-18
Write Calibration to Flash" on page 1-20
Audio Recording Test (if option installed)" on page 1-21
Read Error Log - Final" on page 1-22
ZOLL AED Pro Service Manual
Chapter 1
®
unit.
1–1