Replacing the defective CMOS battery
Figure 267: Replacing the CMOS battery
▶ Press the locking spring into direction of the arrow (1), so that the CMOS
battery jumps out of its socket.
▶ Remove the CMOS battery (2).
CAUTION
Sharp tools such as screwdrivers might damage system board
components in case of slipping.
▶
If the CMOS battery cannot be ejected without the help of a tool,
it is recommended to use a tooth pick.
▶ Insert the same type of CMOS battery (3) and push it down to secure it (4).
Concluding steps
▶ Dispose of the CMOS battery in accordance with local regulations
concerning special waste.
▶ Install the riser module 2, see
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
GX2560 M7
"Installing the riser module" on page
49.
56.
58.
Upgrade and Maintenance Manual
System board and components
64.
285