Machine Menu; Querying System Information - Hettich ROTOFIX 46 Operating Instructions Manual

Setting the rotor preheating
7.5

Machine Menu

7.5.1

Querying system information

Parameter query
AB4600en
The preheating speed is adjustable from 500 RPM up to the maximum rotor
speed in increments of 10 RPM. It is preset to 500 RPM.
The rotor is stationary.
The lid is open.
1. Press and hold the
'RPM = XXXX' is displayed after 8 seconds.
��
2. Set the desired preheating speed using the rotary knob.
[START/IMPULS] button.
3. Press the
�� The settings are stored.
'*** ok ***' is displayed briefly.
4. To exit the indicator: Press the
button for 8 seconds.
The rotor is stationary.
1. Press and hold the
'SOUND/BELL' is displayed.
��
[SELECT] button repeatedly until 'FU/CCI – S.' is displayed.
2. Press the
Program version for the frequency converter
[SELECT] button repeatedly until 'HOURS' is displayed.
3. Press the
Internal operating hours (the time during which the centrifuge was
switched on)
4. Turn to the right with the
'STARTS' is displayed.
��
Number of centrifugation runs
5. Turn to the right with the
'ROTORCHG1' is displayed.
��
Internal operating hour of the last rotor change
6. Turn to the right with the
'ROTORCHG2' is displayed.
��
Internal operating hour of the penultimate rotor change
7. Turn to the right with the
'OPhoursCHG' is displayed.
��
Internal operating hour of the last operating hours change
8. Turn to the right with the
'IMBALCHG' is displayed.
��
Internal operating hour of the last imbalance cut-off change
9. Turn to the right with the
'OffsetCHG' is displayed.
��
Internal operating hour of the last offset adjustment
10. Press the STOP/OPEN button to exit the menu.
Rev.: 09 / 11.2023
[Preheating] button.
[STOP] button or do not press any
[SELECT] button for 8 seconds.
[Rotary knob] .
[Rotary knob] .
[Rotary knob] .
[Rotary knob] .
[Rotary knob] .
[Rotary knob] .
Software operation
29 / 39