Inserting And Removing Adapters - Hettich ROTOFIX 46 Operating Instructions Manual

Removing the bucket
6.4

Inserting and removing adapters

Inserting
the adapter
removing
AB4600en
Buckets marked with the number of the rotor location may
only be used there.
Buckets marked with a set number may only be used
together.
1
2
3
1. Check that the rotor is firmly seated.
2. Grease the trunnions (3).
3. Insert the bucket (1) into the rotor from above. The trunnions (3) must
be in the grooves (2).
4. Push the bucket (1) down as far as it will go.
Pull the bucket (1) vertically upwards out of the rotor.
1
2
Insert the adapter (1) vertically into the bucket (2) from above.
Remove the adapter (1) vertically upwards out of the bucket (2).
Rev.: 09 / 11.2023
Operation
1
2
3
1
2
21 / 39