Opening Or Loading Programs; Entering Or Changing Programs; Rotor Detection; Heating - Hettich ROTOFIX 46 Operating Instructions Manual

7.2.2

Opening or loading programs

7.2.3

Entering or changing programs

7.3

Rotor detection

7.4

Heating

AB4600en
[Rotary knob] to set 'OFF' or 'ON' .
3. Use
OFF = The programs are not write-protected
ON = The programs are write-protected
[START/IMPULS] button.
4. Press the
�� The setting is stored.
'*** lock ***' is displayed briefly.
If ON is set:
'*** ok ***' is displayed briefly.
If OFF is set:
[SELECT] button to select the 'PROG RCL' parameter.
1. Use the
2. Use the [Rotary knob] to set the desired program location.
[START/IMPULS] button.
3. Press the
'*** ok ***' is displayed briefly.
��
The centrifugation data of the desired program location is dis-
played
4. To check the parameters: Press the
6. To exit the parameter indicator: Press the
press any button for 8 seconds.
1. Retrieve program.
2. If required: Press the
'> <' ).
indicator (
3. If required: Press the
and set it with the
The parameters t/min and t/sec must be set to 0 with the
knob] to set continuous operation. Continuous operation is shown in
'¥' .
the indicator with
[SELECT] button to select the 'PROG STO' parameter.
4. Use the
5. Use the [Rotary knob] to set the desired program location.
[START/IMPULS] button.
6. Press the
�� Settings are stored in the desired program location.
'*** ok ***' is displayed briefly.
The settings are always stored in program location # if the
IMPULS] button is pressed without the 'PROG STO' parameter
being selected.
■
Rotor detection is performed after starting a centrifugation run.
■
If the rotor has been changed, the centrifugation run is cancelled after
rotor detection. The rotor code (red) is displayed.
■
If the maximum speed of the rotor used is less than the set speed, the
speed is limited to the maximum rotor speed.
During the centrifugation run, the centrifuging chamber is heated to the
preselected temperature if required. The heating is switched off when the
rotor is at a standstill.
Rev.: 09 / 11.2023
[SELECT] button several times.
[STOP] button or do not
[RCF] button to toggle between RPM and RCF
[SELECT] button to select the desired parameter
[Rotary knob] .
Software operation
[Rotary
[START/
27 / 39