Enabling Extra Debug Displays - evertz 5550 Operating Instructions Manual

%
DEBUG MODE
debug mode off
debug mode on
%
OPERATION
The MATRIX START menu item is used to adjust starting position where
the time code matrix detector will look for the time code matrix. To access
the MATRIX START menu item, you must first turn DEBUG MODE on.
(See section 3.3.9) Under normal circumstances this value should not
need to be changed from the factory default value. Use the ! and "keys
to adjust.
You must turn off DEBUG MODE before normal operation of the 5550 can
resume.

3.3.9. Enabling Extra Debug Displays

debug mode There are some extra debug displays that you may be
asked
troubleshooting problems. When debug mode is on, several
debug displays are added to the extended displays. These are
listed in Figure 3-4, in the manual.
Debug mode should be left off unless Evertz staff otherwise directs you.
Some of the normal functions of the 5550 are not available with
DEBUG MODE ON, therefore you must turn DEBUG MODE OFF before
normal operation of the 5550 can resume.
Model 5550 Universal Film Data Decoder Manual
to display by Evertz Factory personnel
Page 3-13
when