Analog Input 0 (J105); Table 2-33: Analog Input Connector Pin Assignment (J105) - Aerotech Ensemble CL Hardware Manual

Installation and Configuration

2.5.7. Analog Input 0 (J105)

Analog Input 0 is a 16-bit differential input that accepts a voltage in the range of ±10 V with a resolution of 305
µV. Signals outside of this range may damage the input. To interface to a single-ended (non-differential)
voltage source, connect the signal common of the source to the negative input (pin 14, ANALOG_IN-) and
the analog source signal to the positive input (pin 13, ANALOG_IN+). A floating signal source should be
referenced to the signal common (pin 23, AGND) as shown in
Table 2-33: Analog Input Connector Pin Assignment (J105)
Pin# Description
13 Analog Input 0 + (Differential)
14 Analog Input 0- (Differential)
23 Analog Common
+
-
www.aerotech.com
ANALOG IN+
J105-13
SHIELDED
SIGNAL
CABLE
SOURCE
ANALOG IN-
J105-14
AGND
J105-23
Figure 2-38: Analog Input 0 (J105)
Chapter 2
Figure 2-38.
100
+
.1
-
100
Ensemble CL
In/Out/Bi
Input
Input
-
55