Signal Channel Output Amplifiers - Ametek 7124 Instruction Manual

3 100 µs
4 200 µs
5 500 µs
6 1 ms
7 2 ms
8 5 ms
9 10 ms
10 20 ms
11 50 ms
12 100 ms
13 200 ms
14 500 ms
15 1 s
N/A means that n is an illegal value under these conditions.
The TC. command is only used for reading the time constant, and reports the current
setting in seconds. Hence if a TC 12 command were sent and the noise measurement
mode was turned off, TC would report 12 and TC. would report 1.0E-01, i.e. 0.1 s or
100 ms.
SYNC [n] Synchronous time constant control
n Effect
0 Synchronous time constant disabled
1 Synchronous time constant enabled
SLOPE [n] Output low-pass filter slope (roll-off) control
When the fast analog output mode and Noise Measurement mode are turned off
(FASTMODE 0 and NOISEMODE 0), the selection is according to the following
table:
n Slope
0 6 dB/octave
1 12 dB/octave
2 18 dB/octave
3 24 dB/octave
When:
a) The fast output filter mode is turned on, or
b) Noise measurement mode is turned ON (NOISEMODE 1)
the selection is according to the following table:
n Slope
0 6 dB/octave
1 12 dB/octave

6.7.04 Signal Channel Output Amplifiers

XOF [n [n ]] X channel output offset control
1 2
n Selection
1
0 Disables offset
1 Enables offset facility
The range of n is ±30000 corresponding to ±300% full-scale.
2
YOF [n [n ]] Y channel output offset control
1 2
Chapter 6, COMPUTER OPERATION
N/A 19
N/A 20
500 µs 21
1 ms 22
2 ms 23
5 ms 24
10 ms 25
N/A 26
N/A 27
N/A 28
N/A 29
N/A 30
N/A
20 s N/A
50 s N/A
100 s N/A
200 s N/A
500 s N/A
1 ks N/A
2 ks N/A
5 ks N/A
10 ks N/A
20 ks N/A
50 ks N/A
100 ks N/A
6-15