Table of Contents
Advertisement
TABLE OF CONTENTS
Avoid Unsafe Equipment
The equipment may be unsafe if any of the following statements apply:
Equipment shows visible damage.
Equipment has failed to perform an intended operation.
Equipment has been stored in unfavorable conditions.
Equipment has been subjected to severe physical stress.
If in any doubt as to the serviceability of the equipment, don't use it. Get it properly checked out by a
qualified service technician.
Live Conductors
When the equipment is connected to its measurement inputs or supply, the opening of covers or
removal of parts could expose live conductors. The equipment must be disconnected from all power
and signal sources before it is opened for any adjustment, replacement, maintenance or repair.
Adjustments, maintenance or repair must only be done by qualified personnel, who should refer to the
relevant maintenance documentation.
Equipment Modification
To avoid introducing safety hazards, never install non-standard parts in the equipment, or make any
unauthorized modification. To maintain safety, always return the equipment to your
SIGNAL RECOVERY service provider for service and repair.
European WEEE Directive
This product is subject to Directive 2002/96/EC of the European Parliament and the Council of the
European Union on waste electrical and electronic equipment (WEEE) and, in jurisdictions adopting
that Directive, is marked as being put on the market after August 13, 2005, and should not be disposed
of as unsorted municipal waste. Please use your local WEEE collection facilities for the disposal of this
product and otherwise observe all applicable requirements.
FCC Notice
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with this instruction manual, may cause harmful interference with radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which case
the user is required to correct the interference at his own expense.
Acknowledgment
Operation of the Ethernet interface in the model 7270 relies on software code developed by the
Swedish Institute of Computer Science, copyright 2001-2004, all rights reserved. In accordance with
the license under which it is used, we reproduce here the following disclaimer:
THIS SOFTWARE IS PROVIDED BY THE AUTHOR ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES,
INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT,
INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO,
PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS
SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
viii
Advertisement
Table of Contents
