Table of Contents
Advertisement
To open, press the EPG button in TV mode. By default, the Grid EPG is set, which gives you a better
overview of the current programme on several different channels. On the left you will see the channel
list, on the right the events preview with the event information for the next hours. The corresponding
short information about the selected event is displayed in the upper right of the screen with the start
and end of the event. Use the pq buttons to select the desired channel, then press OK to switch to the
channel and load its information. If you press OK again on you will directly switch to TV mode. Use u
to highlight a particular event of the selected channel. Press INFO to display detailed information and
press to close it again. Press the BLUE button to go 6 hours forwards and press the YELLOW button
to go 6h backwards (not further than to current time). To go directly to the current time use the GREEN
button. The RED button allows you to book a timer for a selected event and with LIST you can open the
timer list.
For details on editing timers, see chapter 7.3.4 Timer, the function is identical.
Use the EPG button to switch to Single EPG.
Single EPG
In this form of the EPG, you always see the list of information for the selected channel on the right where
you can use pq to select an event. The corresponding event description is located in the lower area. To
go to the next or previous day, use the BLUE and YELLOW buttons, to return to the current contents use
the GREEN button. The remaining functions stay as described above. To switch to the Grid EPG use the
EPG button and to leave the menu use or press OK for a 2nd time on the selected channel.
NOTE:
7.0 MAIN MENU
Press MENU in viewing mode to display the main menu. All important settings and features of your
receiver can be operated from there. It consists of the following sub-menus: Installation, Channels,
Settings, Multimedia, Update, CA Menu and Network
Use t u to select a sub-menu and pq to choose an option. Press OK to open the chosen submenu.
7.1 Installation
Press MENU and select Installation with t u. The following sub-menus are available: Antenna Setup,
Motor Setting, Channel Search and Factory Reset.
7.1.1 Antenna Setup
In this menu, you can change and adapt settings for the antenna(s) and their transponders. Use the t u
buttons to change settings, and use pq to select an item, or press OK to list the settings. For the default
setting of DiSEqC 1.0, you can set the parameters for up to 4 satellite positions Port 1-4.
Satellite
LNB Power
LNB Type
Availability of EPG data depends on broadcast and can be displayed for up
to 7 days. If you are opening the EPG just after the receiver was switched on
or you change to another transponder we recommend to wait for a short
moment in order to collect the data.
Press OK to open the list of available satellites. Select the desired satellite with
pq or P+/P- and confirm with OK.
If necessary, you can change the LNB voltage using the t u buttons.
Select the desired LNB type using the t u buttons if you are not using a
universal LNB. Available are: C Band, SatCR and User defined.
13
Advertisement
Table of Contents
