Status Commands; Table 51 Paper Sensor Status (<N> = 1, 49) - TransAct POSjet 1500 Programmer's Manual

Programmer' s Guide

Status Commands

Function Transmit Status
ASCII
[GS] r <n>
Hexadecimal
1DH 72H <n>
Decimal
<29> <114> <n>
Range 1 ≤ n ≤ 2
49 ≤ n ≤ 50
Description
The [GS] r <n> command transmits the status specified by <n> as follows: paper sensor status as
one byte of data when <n> = 1 or 49, and drawer kick-out connector status when <n> = 2 or 50.
The paper present status of bits 2 and 3 for the paper sensor status is not transmitted because the
printer goes off line when a paper out is detected by the paper out sensor. The paper roll low
sensor is an option. If the sensor is not installed, bits 0 and 1 for the paper sensor status are always
in the "Paper adequate" status.
Bit Off/On
0 Off
On
1 Off
On
2 Off
On
3 Off
On
4 Off
5,6 -
7 Off
Nov-07
®
POSjet
Hex Decimal
00H <0>
01H <1>
00H <0>
02H <2>
00H <0>
04H <4>
00H <0>
08H <8>
00H <0>
- -
00H <0>
Table 51 Paper Sensor Status (<n> = 1, 49)
Rev M
1500
Status
Journal Memory adequate
Journal Memory low (Less than 8K)
Paper low sensor: paper adequate
Paper low sensor: paper low
Journal Memory adequate
Journal Memory exhausted.
Paper out sensor: paper present
Paper out sensor: paper not present
Not used; fixed to Off
Undefined
Not used; fixed to Off
EPOS Control Codes
Page 219