Table 49 Paper Sensor Commands - TransAct POSjet 1500 Programmer's Manual

Programmer' s Guide
Function Select Paper Sensor(s) to Output Paper-End Signals
ASCII
[ESC] c 3 <n>
Hexadecimal
1BH 63H 33H <n>
Decimal
<27> <99> <51> <n>
0 ≤ n ≤ 255
Range
Description ESC c 3 n selects whether to output paper-end signals or not to a parallel interface. The default
setting is n=15. The paper roll low, paper roll end, and validation sensors can be selected. When
the sensors are selected to output signals and any sensor detects a paper-end, the paper-end signal
is output. When all sensors are disabled, and a paper out is detected, status is always a paper
present. The paper roll low sensor is enabled when either bit 0 or bit 1 or both is on. The paper roll
end sensor is enabled when either 2 or 3 or both bits is on. The validation sensor is enabled when
either 6 or 7 or both bits are on. This command is enabled only with a parallel interface and is
ignored with a serial interface.
The paper sensor(s) used to output paper-end signals are selected by using n as follows:
Bit Off/On
0 Off
On
1 Off
On
2 Off
On
3 Off
On
4-5 —
6 Off
On
7 Off
On
Note: The electronic journal will not stop the printer. Bits 0,1,2 and 3 all control the receipt station.
Nov-07
®
POSjet 1500
Hex Decimal
00 0
01 1
00 0
04 2
00 0
04 4
00 0
08 8
— —
00 0
40 64
00 0
80 128

Table 49 Paper Sensor Commands

Rev M
EPOS Control Codes
Function
Paper roll low sensor disabled.
Paper roll low sensor enabled.
Paper roll low sensor disabled
Paper roll low sensor enabled.
Paper roll end sensor disabled.
Paper roll end sensor enabled.
Paper roll end sensor disabled.
Paper roll end sensor enabled.
Undefined.
Validation sensor disabled.
Validation sensor enabled.
Validation sensor disabled.
Validation sensor enabled.
Page 215