Validation Operation Control - TransAct POSjet 1500 Programmer's Manual

Programmer' s Guide
Function Load to top of form
ASCII [ESC]m
Hexadecimal
1BH 6DH
Decimal
<27> <109>
IPCL
&%VD
Description
Position a form to the top edge. This command is typically used to print the face of a check in
rotated print mode. It will feed the check into the printer so the top of the check is in position to
print.
CAUTION: This command should only be used with forms that are narrower than 70mm (2.75
are wider than 70 mm (2.75") will jam and could cause a printer fault.

Validation operation control

®
The POSjet 1500 supports a number of commands that alter the way the validation operates.
Function Set Wait for slip Timeout
ASCII [ESC][EM]C<n>
Hexadecimal 1BH 19H 43H<n>
Decimal <27> <25><67><n>
IPCL
None
EPOS
Description
This command sets the period of time the printer will wait for the form or check to be presented to
the printer before the validation command is aborted. The default is to wait forever.
Where n =
0
1
...
255
Nov-07
POSjet
Wait forever
10 Seconds
42.5 minutes.
Rev M
®
1500 Codes and Commands
inches). Forms that
Page 159