TransAct POSjet 1500 Programmer's Manual page 190

Control Codes
Function Select Paper Sensor(s) to Output Paper-End Signals
ASCII [ESC] p 3 <n>
Hexadecimal
1BH 70H 33H <n>
Decimal
<27> <112> <51> <n>
Range 0 ≤ n ≤ 255
Description
The [ESC] p 3 <n> command selects the paper sensor that outputs a paper out signal to the parallel
interface when a paper out is detected. The default setting is when all sensors are enabled. (<n> =
15). It is possible to select multiple sensors to output signals. If any of the sensors detect a paper
out, the paper out signal is output. The command is only available with a parallel interface. The
paper out sensor is an option. If the sensor is not equipped, the settings of bits 0 and 1 of the
command are not effective.
Bit On/Off
0 Off
On
1 Off
On
2 Off
On
3 Off
On
4-7 -
Function Enable print suppress and data pass through
ASCII
[ESC] < <n>
Hexadecimal
1BH 3CH <n>
Decimal <27> <60> <n>
IPCL
&%PT <n>
EPOS
[ESC] = <n>
Description
The [ESC] < <n> command provides print suppress and data pass through features.
Where Bit 0
Bit 1
Bits 2 - 7
If Bit 0 is clear, the printer stops processing data. If Bit 1 is set, the data is passed through the
printer and sent out on the serial port.
Note 1
The pass through command is preprocessed. It is processed as soon as it is received. The printer
may continue to print while previously received data is processed. The printer must be on-line and
ready to activate the command.
Note 2
Pass through should only be used with serial printers. If the printer is configured for parallel
operation, the data is still pass through on the IEEE 1284 port. In most cases this is not useful.
Note 3
When Ithaca
Series 50 Printer pass through must be used.
Note 4
Multi-drop is not operational during suppress and pass through. If a multi-drop address is present
in the pass through data, it is not processed.
Page 176
®
POSjet 1500
Hexadecimal Decimal
00H <0>
01H <1>
00H <0>
02H <2>
00H <0>
04H <4>
00H <0>
08H <8>
- -
Table 39 Paper Sensor Commands
Printer select
Pass through On
Undefined
®
Series 50 Printer compatibility is being used, these commands do not function.
Rev M
Programmer' s Guide
Function
Paper roll low sensor disabled
Paper roll low sensor enabled
Paper roll low sensor disabled
Paper roll low sensor enabled
Paper roll end sensor disabled
Paper roll end sensor enabled
Paper roll end sensor disabled
Paper roll end sensor enabled
Undefined
Nov-07