TransAct POSjet 1500 Programmer's Manual page 70

Control Codes
If active, a false CTS prevents the printer
CTS Signal
from sending any data to the host
Not Used
Active
The multi-drop feature is activated at power up
Multidrop
when set to an address.
Off
A Device
B Device
C Device
Validation Control
If this option is set, the printer will remain in
Slip Auto
validation select mode until the form is inserted
Reload
correctly. If this mode is off the printer will
report an error to the host is the slip is not
inserted correctly. If this option is off, the host
must assure that the form is correctly inserted
before the validation information is sent to the
printer.
By default, pressing the FORM button will
Manual Slip
cause the printer to enter validation mode. This
Load
feature may be disabled by turning this option
off.
If this option is selected, any information printed
Auto Journal
on a validation form will also be placed in the
Slip
Electronic Journal.
By default, pressing the FORM button while the
Allow Form
printer is requesting a form will abort the form
Abort
request and return to receipt mode. This option
will disable this feature
This sets the time the printer waits for a
Form Insert
validation form before returning to receipt
Timer
mode.
This sets the time the printer waits for a
Form
validation form to be removed before returning
Remove
to receipt mode
Timer
This specifies the default load point for
Default Slip
validation forms.
Stop
This option is available in M50 and Microline
M50
emulations. It compresses the print (Vertically)
Validation
to allow applications written for the M50 to print
the same number of print lines on the 1500
This options sets the default left margin in
Validation
validation mode.
Left Margin
This sets the time the printer waits after a form
Form Sense
is sensed until the form is loaded.
Delay
Electronic Journal
Page 56
®
POSjet 1500
Rev M
Programmer' s Guide
•
This option is available in
PcOS, M50 and Microline
only.
•
On
ON
Off The Electronic Journal must be
active for this option to function.
Enabled
• Disabled to 10 Min.
• Disabled to 10 Min.
Note: There is a 1 Second Option
that is useful in some systems.
40 mm. This value should not be set
greater than 40mm unless the
inserted form will always be less
than 70mm (2.75") wide.
Normal M50 and Microline only
0
100 ms. to 100 ms. to 1 Sec.
1 Sec.
• 300 ms. to 1 Sec.
Nov-07