Table of Contents
Advertisement
EPOS Control Codes
Function
Define User-Defined Characters
ASCII
[ESC] & <y> <c1> <c2> [x1 d1 ... d(y x x1)] ... [xk d1 ... d(y x xk)]
Hexadecimal
1BH 26H y c1 c2 [x1 d1 ... d(y x x1)] ... [xk d1 ... d(y x xk)]
Decimal
<27> <38> y c1 c2 [x1 d1 ... d(y x x1)] ... [xk d1 ... d(y x xk)]
Range
y = 2
32 ≤ c
≤ c
1
0 ≤ x ≤ 12 (9 x 9 font)
0 ≤ x ≤ 9 (7 x 9 font)
0 ≤ d
... d(y x x) ≤ 255
1
Description
The [ESC] & <y> <c
defined characters from character code <c
defined characters. <y> specifies the number of bytes in the vertical direction. <x> specifies the
number of bytes in the horizontal direction. Character codes ranging from ASCII code 20H (32)
to 7EH (126) can be defined by <c
Data (<d>) specifies a bit printed to one and not printed to zero. At the default, user-defined
characters are not defined, and the internal character set is printed. Once the user-defined
characters have been defined, they are available until [ESC] @ or [ESC] ? is executed; the user-
defined characters are redefined; the power is turned off; or the printer is reset.
Note 1
In TM-U325D mode, the buffer must be set to 40 characters or the command will not function.
Function
Cancel User-Defined Characters
ASCII
[ESC] ? <n>
Hexadecimal
1BH 3FH <n>
Decimal
<27> <63> <n>
32 ≤ n ≤ 126
Range
Description
The [ESC] ? <n> command cancels the user-defined characters defined for character code <n>.
After the user-defined characters are canceled, the internal character set is printed.
Note 1
In TM-U325D mode, the buffer must be set to 40 characters or the command will not function.
Function
Select an International Character Set
ASCII
ESC R <n>
Hexadecimal
1BH 52H <n>
Decimal
<27> <82> <n>
0 ≤ n ≤ 74
Range
Default
<n> = 0
Description
The ESC R <n> command selects an international character set, <n>, from the following table.
Page 206
®
POSjet
≤ 126
2
> <c
> [x
d
1
2
1
1
> and <c
1
Rev M
1500
... d(y x x
)] ... [x
d
... d(y x x
1
k
1
> to <c
>. <y> and <x> are the configurations of user-
1
2
>. Up to 19 user-defined characters can be defined.
2
Programmer' s Guide
)] command defines user-
k
Nov-07
Advertisement
Table of Contents
Troubleshooting
